Incinerator Model TS250 PLC, Overview

This model is small-scale waste incineration equipment for small waste output. Construction 

is dual/double combustion chamber with 02 units oil burner, batch load incineration equipment. 
Waste feed chamber is 1800Liters (1.8m3, TS250 PLC). Primary & Secondary combustion chambers
and smoke filter chamber. Batch load on the bottom of chamber. Incinerator PLC panel control suit for local operation. 

Main Product List per 01 set

Primary Combustion Chamber

Secondary Combustion Chamber

Smoke Filter Chamber

Incinerator PLC Control Case

Chimney:10.0Meters

*(upgrade to Stainless Steel, free cost)

Italy oil/gas burner: 02 units

Oil Tank (if oil fuel): 300Liters








Items/Model

TS200(PLC)

Picture

 

Principle

Solid Waste Incineration Treatment

Burn Rate

Average 250 kg/hour

Feed Capacity

Average 350kg/feeding

Control Mode

PLC(Programmable Logic Controller Incinerator)

Combustion Chamber

1800L

Internal Dimensions

150x110x110cm

Secondary Chamber

750L

Smoke Filter Chamber

Yes

Feed Mode

Manual

Voltage

220V

Power

0.9Kw

Oil Consumption (kg/hour)

Average 28

Gas Consumption (m3/hour)

Average 33.6

Temperature Monitor

Digital Display

Temperature Protection

Yes

Oil Tank

300L

Feed Door

80x60cm

Chimney

10Meter

Chimney Type

Stainless Steel

1st. Chamber Temperature

800-1000

2nd. Chamber Temperature

1000-1200

Residency Time

2.0 Sec.

Gross Weight

8500kg

External Dimensions

300x160x190cm

Burner operation should be Automatic On/Off

Fuel : diesel

The supplier must provide  necessary information for the best of  the installation

This incinerator with “PYROLYTIC” combustion must have:

;

・ Refractory concrete :

§ . Thickness : ≥100 mm

§ . Nature: 42% of Al203

・ Insulate in fibrous panels :

§ . Thickness: ≥75 mm

・ Nature: Calcium silicate.

* Burner of lighting of waste, with fuel, standard mono-bloc casting guiding plunging flame, lighting and safety of electronic ignition, permanent ventilation, electromagnetic sluice gate of regulation and isolating valve.

* Plate of combustion in Carborundum, avoiding the fixing of glass and slags.

 

A chamber of post combustion of gases

* A burner of combustion of gases,

* A device of injection of air allowing a total recombustion of gases,

* A device of air inlet of cooling of waste gases,

* A sheath of evacuation of the gases burnt.

* Carcass in strong sheet steel with support of connection.

* Composition of the refractory;

・ Refractory concrete :

§ Thickness : ≥150 mm

§ Nature: 65% of Al203

・ Insulate in fibrous panel :

§ Thickness: ≥85 mm

 Nature: Calcium



Categories:

Tags:

Comments are closed

www.waste-incinerator.net
Open chat
Powered by